The body is now mounted on a rotisserie so repairs and painting underneath can be done .
Left Chassis rail at rear has been patched in the past with piece of Steel Pop riveted in place.
Patch Removed to reveal a large rust hole underneath . A new piece of steel will be welded into place to restore the strength to the chassis section.
New Steel welded into the Chassis section .
We are now at the stage where the old paint has to be removed and new paint applied since all of the rust has been repaired . The sheet metal is in very good condition under the paint which is nearly all original and never been repainted .
Big Surprise today,Saturday 9/05/15. The roofers finally turned up to repair the damn roof. Because the old one was asbestos sheet,the whole shop had to sealed up while they removed every on top of the building. Amzingly it took only 8 hours to strip the old roof off and fit insulation ,then fit the new Zincalume roof.
Brilliant light now!.
I’ve been restoring a 190SL for an owner and part of the task involves rebuilding it’s non standard DCOE carbs. A lot of W121’s were fitted with these over years to get around the problems thrown up by the awful Solex side draft carbs originally fitted.
Carb on the left has been rebuilt
Carb on the right is in as is condition with blocked jets and water damge
As can be seen in the left photo the chokes have signs of water from the fuel supply.Carb on the right after stripping ,wet blasting and rebuilding.
Below is how the original fuel pipe looked before restoration .
Below the original pipe after replating the pipe and ferules with the ends resoldered back in place.
Temporary mock up of the rear carb in place.
benzkraft 