6/03/2107 A weeks work has seen the whole body shell stripped to the bare metal , but yet more damage has been uncovered . the top pics illustrate the panel below the tail lights. instead of repairing these,i will make new ones and weld them in ,it’s easier than trying to fix some butchers efforts in the past.  The boot floor at the bottom has been cleaned properly and rust proofed. the front guards are stripped and the exposed damage is in the process of being repaired.  Shown in the bottom right pic they are being fitted to try for fit .

Right rear Fender After paint has been removed which has uncovered a lot of small dents from a previous bad repair . A bit hard to see here but the panel is pushed in 8mm and will have to be bumped back to shape.

Bottom of right rear fender ,has had a patch roughly welded into place .Again this will have to be straightened out before painting. 

15″ x 7″ rims for another Project…..

Rear Axle was leaking so the boot was inspected ,and was found to be leaking because of this break . 

Rear homokinetic Joint is in good condition .

Pivot Bush is worn and will be replaced.

Boot interior had been brush painted in body colour ,over a bitumous based underseal ,so was not very attractive at all.  All of this coating has been removed and will repainted in the correct Dark gray .Lots of surface rust was found under this coating and this will treated to prevent it coming back. Coatin

C

Inside the rear wheel houses ,I found the rear vent drains blocked with something…ominous. 

Some one has taped over the rusted drains with masking tape and painted them…

Dents in the roof, hidden under 5mm of filler

The repair of the roof is on going ,mostly the removal of lots of hail dents but the latest discovery were a line of strange dents as if the roof had a bulge in it and some one has bashed it down .

The Primer Was sanded back and a lot of small dents were revealed . Several more coats of Primer were Applied and sanded back again .

Some low spots were removed then the odd high spot shrunk back ..

Phil, the cars owner came over from Western Australia to lend a hand with the more tedious jobs. 

Fresh out of the Spray booth in Horizon Blue . At this point I was not happy with overall smoothness of the clear coat so…

I have Flatted it back with 2000 grit wet and dry ,to be followed with 3000 then polished.

During this part of the process a few high spots were revealed …again so these have been shrunk back and will be repainted .

Steering Column has been stripped, repainted with new bushes and top bearing.The cast alloy base plate has been wet blasted with the gearshift bushes replaced.

Replated Gear shift Links.

Air cleaner body has been straightened out and repainted. 

The steering Wheel needs restoration as it is full of cracks. plus the plugs for the Center cap are broken. these will be replaced. 

Mercedes 220S Convertible project .

Wiring Loom Restoration begins :

The Loom is stretched out on a panel so all parts can be examined. So far the obvious problem area are where odd wiring has been added to accommodate a radio..

The little silver box in the above picture is a pair of switches for an added on wash/wipe system. 

Head light plugs and horn wires ,all covered in paint sometime in the past. 

Firewall Plug , Loom covering has been removed and covered loosely in tape in the past .

Firewall plug on Drivers side with ignition switch and light switch Again loom covering is badly damaged..

230S and 220S 4.5