280SE engine build part 2

Today was spent assembling the piston and con rod assemblies,fitting the new rings after checking them in the bores to ensure the ring gasp is correct . Then fitting the crank followed by  fitting the crank seal . a little task which can up to an hour to get right so the crank doesn’t leak.

280SE manual trans  M130 008 280SE manual trans  M130 009 280SE manual trans  M130 010 280SE manual trans  M130 011

The block was repainted to an original type of black finish

280SE manual trans  M130 012

280SE manual trans  M130 014

With new side plates and fasteners the short block is beginning to look like an engine again.

1 thought on “280SE engine build part 2

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s